The DynaVap M7 is a manual, battery-free dry herb vaporizer made from stainless steel. It uses DynaVap's Thermal Extraction system and is heated externally with a torch, lighter or induction heater.

Yes. The M7 is known for efficient extraction, strong flavor, low herb consumption and excellent durability. It does not require batteries or charging.

Load dry herb into the tip chamber, place the Captive Cap on top and heat the Cap with a torch or induction heater. When the Cap clicks, stop heating and inhale through the mouthpiece.

The M7 uses a combination of conduction and convection heating. The heated tip transfers heat directly to the herb while airflow also contributes to the extraction process.

The click from the Captive Cap indicates that the device has reached the intended vaporization range. Stop heating immediately after the click. The Cap will click again as it cools down.

The M7 can be heated with a torch or an induction heater. When using a flame, rotate the device during heating for more even heat distribution and stop as soon as the Cap clicks.

Heating time depends on the heat source and technique. With a torch it usually takes only a few seconds. The click, rather than a fixed number of seconds, should be used as the main indication that the device is ready.

There is no electronic temperature control. The user controls the heating process with the heat source and technique, while the Captive Cap provides an audible temperature signal.

No. The M7 contains no battery or electronics. It works with an external heat source such as a torch or induction heater.

No. It is completely battery-free, so there is no charging and no USB cable required for operation.

The standard M7 chamber holds approximately 0.1 g of dry herb. The Adjust-a-Bowl feature allows the chamber size to be reduced by approximately half.

Yes. The Adjust-a-Bowl feature reduces the chamber size, making the M7 suitable for smaller loads and microdosing.

Yes. The M7 is primarily designed for vaporizing dry botanical material.

The standard M7 configuration is designed for dry herbs. DynaVap offers additional accessories for other applications, so concentrates should not be placed directly into the standard chamber.

Yes. The M7 is compatible with 10 mm water pieces, allowing it to be connected to a compatible bong or bubbler for water filtration.

Yes. The M7 features an updated airport and Pivot-style airflow control that allows you to adjust the airflow while inhaling.

The M7 does not use a fixed electronic session timer. Each heating cycle continues until the Cap cools down, after which the device can be reheated for another extraction cycle.

Yes. The M7 is designed for efficient extraction and can produce dense vapor from a relatively small amount of herb. Results depend on the material, grind, moisture level and heating technique.

Remove the Cap, load the chamber, replace the Cap and heat it with a torch or induction heater. Rotate while heating and stop immediately when it clicks. Inhale through the mouthpiece, then wait for the cooldown click before reheating.

The M7 can be disassembled and cleaned regularly. Metal parts can be cleaned with isopropyl alcohol after removing the O-rings. Keeping the device clean helps maintain airflow and flavor.

Yes. Remove the O-rings before cleaning metal components with isopropyl alcohol, as alcohol can dry out the seals. Allow all parts to dry completely before reassembly.

The M7 is ideal if you want a battery-free device, excellent durability, efficient herb use and hands-on control of heating. An electronic vaporizer is more convenient if you prefer a display, buttons and precise digital temperature settings.

Yes, although it takes a little practice to master the heating technique. The most important beginner rule is simple: stop heating immediately when you hear the click.